Skip to main content

Thrust or Thrust Sync: stroking or vibration isn't working

Quick checks for Thrust and Thrust Sync, and what to send us if it still isn't right.

Written by Leah H

Quick checks

  1. Charge it fully with the original Erojoy cable that came in the box.

  2. Push the sleeve all the way in. A safety feature stops the motor unless the sleeve is fully seated.

  3. Test each mode. Turn the device on, press the power button to cycle through the stroking modes, then press the vibration button and check that it responds.

  4. Thrust Sync with video? If it works on its own but not with video, see Thrust Sync or X3 won't connect or sync with video.

Important: never move the stroking parts by hand, even when the device is off. It can damage the mechanism, and that damage isn't covered by the warranty.

Still not working? Send us a short video

Email [email protected] with your order number and a short video of you assembling the device and showing the problem. It helps us see whether the motor is working properly. See My device isn't working. How do I make a warranty claim? for what happens next.

Please note: we can't repair, replace or refund a device that has been exposed to water or charged with a cable other than the original.

Did this answer your question?